Figure 2-6.-QA Form 7, Controlled Material Inventory/Record.

Figure 2-6.-QA Form 7, Controlled Material Inventory/Record.

QA FORM 13, QUALITY ASSURANCE

QA FORM 9, RE-ENTRY CONTROL FORM

INFORMATION SHEET

This form (fig. 2-8) is used to document re-entry

This form provides the IMA with the necessary

into a SUBSAFE boundary and is used in a controlled

information to develop a CWP before the start of work.

work procedure.

When filled out, this sheet will be attached to the

4790/2K and delivered to the IMA. For CSMP entries,

QA FORM 9A, RE-ENTRY CONTROL

this form is delivered to the IMA at the pre-arrival

SUPPLEMENT SHEET

conference.

This sheet supplements QA Form 9 and is used to

QA FORM 15, REQUEST FOR RELEASE OF

record additional information.

REJECTED MATERIAL OR

WORKMANSHIP

QA FORM 10, RE-ENTRY CONTROL LOG

Should there be an urgent and overriding

requirement for the use of material or workmanship, the

The re-entry control log (fig. 2-9) is used to provide

a chronological record of re-entry into SUBSAFE

division officer/production officer may request that the

repair officer and squadron material officer release

boundaries. Each time a QA Form 9 is used, the IMA,

rejected material or workmanship. For example, a shaft

QAO, or ship's engineer must log the time issued and

has been machined undersize, but it is determined that

serial number assigned on QA Form 10.

2-17